WaterBoss Water Softener Maintenance & Repair Test Flow Sensor 3 Easy Steps Please share this video 
• WaterBoss Water S... For more great information about water treatment, subscribe! / waterstoremidland Check out our Ultraviolet Playlist here • Viqua UV Systems Follow mehttps://www.facebook.com/TheWaterEstore/https://twitter.com/FilterEstorehttps://www.linkedin.com/company/the-... or email info@TheWaterEstore.com or info@TheWaterStoreMidland.com Check out our online store at https//www.TheWaterEstore.com or our full service store in Midland, Ontario at https//www.TheWaterStoreMidland.com Whenever water flows through a Water Boss water softener, you will see the gallon per minute flow rate displayed on the controller. If nothing is being displayed on the controller when treated water is running in the house you can trouble shoot by testing the sensor. Please note that if the water softener was plumbed backwards it would also not register flow, so check that first. 1) Remove the valve cover and remove the sensor from the Bypass housing. 2) Test with a magnet on either flat side of sensor. If flow is indicated, then the sensor is working and you will need to check the turbine. 3) If no flow is indicated in the magnet test, replace the sensor, if still no flow is indicated after replacing the sensor, replace the circuit board. Please share this video • WaterBoss Water S... Check out all of our WaterBoss videos here • Water Boss High E... For more great information about water treatment subscribe! / waterstoremidland Follow mehttps://www.facebook.com/TheWaterEstore/https://twitter.com/FilterEstorehttps://www.linkedin.com/company/the-... or email info@TheWaterEstore.com or info@TheWaterStoreMidland.com SHOP! Midlandhttps://www.WaterStoreMidland.com Canadahttps://www.WaterEstore.ca USAhttps://www.WaterEstore.com